faqs.org - Internet FAQ Archives

RFC 3827 - Additional Snoop Datalink Types


Or Display the document by number




Network Working Group                                          K. Sarcar
Request for Comments: 3827                        Sun Microsystems, Inc.
Category: Informational                                        June 2004

                    Additional Snoop Datalink Types

Status of this Memo

   This memo provides information for the Internet community.  It does
   not specify an Internet standard of any kind.  Distribution of this
   memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2004).

Abstract

   The snoop file format provides a way to store and exchange datalink
   layer packet traces.  This document describes extensions to this file
   format to support new media.

1.  Introduction

   [RFC1761] defines the snoop file format used to store captured
   network packets for tools that capture, display, and interpret
   network traffic.  The file format specifies a header containing the
   Datalink Type field that identifies the network's datalink type.
   This document defines new values for this field, as well as an IANA
   registry for future datalink types.

2.  New Datalink Types

   In addition to the Datalink Type codes listed in [RFC1761], this
   document defines the following type codes for the corresponding
   media:

             Datalink Type           Code
             -------------           ----

             Fibre Channel           16
             ATM                     17
             ATM Classical IP        18
             IP over Infiniband      26

   The IP over Infiniband packet format is described in [IPoIB].

3.  IANA Considerations

   This document created a new IANA registry named "Snoop Datalink
   Types" to hold the various possible 32-bit (4 octet) snoop datalink
   types.  This new registry holds the values previously defined in
   [RFC1761] and tabulated below:

             Datalink Type           Code
             -------------           ----

             IEEE 802.3              0
             IEEE 802.4 Token Bus    1
             IEEE 802.5 Token Ring   2
             IEEE 802.6 Metro Net    3
             Ethernet                4
             HDLC                    5
             Character Synchronous   6
             IBM Channel-to-Channel  7
             FDDI                    8
             Other                   9

   Additionally, the new registry also holds the values defined above in
   section 2 of this document.

   All new allocations and assignments to this registry starting from
   code 27 will follow the First Come First Served policy outlined in
   [BCP0026].  Type codes up to 26 not defined by this section of the
   document (10-15 and 19-25) are considered reserved.

4.  Security Considerations

   The addition of new datalink type codes to the existing file format
   poses no known security risks.

5.  Acknowledgements

   The author would like to thank Jim Carlson, Brent Callaghan, and Bill
   Strahm for meticulously reviewing this document.

6.  References

6.1.  Normative References

   [RFC1761] Callaghan, B. and R. Gilligan, "Snoop Version 2 Packet
             Capture File Format", RFC 1761, February 1995.

   [BCP0026] Narten, T. and H. Alvestrand, "Guidelines for Writing an
             IANA Considerations Section in RFCs", BCP 26, RFC 2434,
             October 1998.

6.2.  Informative References

   [IPoIB]   Kashyap, V. and H.K. Chu, "IP encapsulation and address
             resolution over InfiniBand networks", Work in Progress,
             April 2003.

7.  Author's Address

   Kanoj Sarcar
   Sun Microsystems, Inc.
   14 Network Circle
   Bldg 14, MPK14-333
   Menlo Park, CA  94025

   Phone: 1-650-786-4785
   EMail: kanoj.sarcar@sun.com

8.  Full Copyright Statement

   Copyright (C) The Internet Society (2004).  This document is subject
   to the rights, licenses and restrictions contained in BCP 78, and
   except as set forth therein, the authors retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at ietf-
   ipr@ietf.org.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.

 

User Contributions:

Comment about this RFC, ask questions, or add new information about this topic: